INSTALLATION INSTRUCTIONS
BOLT-ON STEEL ROLL PAN
PART# 2078101
ACCESSORIES SOLD SEPARTELY:
FLIP-DOWN LICENSE PLATE ASSEMBLY
PART # 300001
TAILGATE HANDLE RELOCATOR
PART # 2078118
For best results, please read all instructions thoroughly prior to attempting installation of your SIR MICHAEL'S bolt-on steel roll pan. PLEASE NOTE, SIR MICHAEL'S recommends the use of approved hand, eye, and ear safety equipment while performing this installation. If you have any questions concerning the Installation of your SIR MICHAEL'S steel roll pan please contact our customer service department at ( 714 ) 379-6800, Monday - Friday between 10:00 a.m. and 4:00 p.m. Pacific Standard Time(PST).
NOTE: Any part that is modified and/or painted is non returnable.
1. Remove the tailgate and/or rear bumper from truck.
2. To avoid damaging the paint on the truck during test fitting, apply masking tape between the bedsides and the SIR MICHAEL'S bolt-on steel roll pan.
3. The roll pan mounts directly to the back of the bed below the tailgate using supplied #8 self-tapping screws. NOTE: It is recommended to pre-drill all mounting holes using 1/8" drill bit once test fitting is complete.
4. Next, drill one ºî hole in the bottom fender lip. Using the ºî bolts provided, secure the roll pan at the ends. Adjust pan to match body lines and tighten all hardware. NOTE: The black plastic name badge on the tailgate must be removed (On vehicles equipped) to avoid rubbing on roll pan.
5. Once the SIR MICHAEL'S bolt-on steel pan is properly fitted, remove to be prepped for paint. A lite coat of boy filler is used to fill the seams around the license plate and at the end of the roll pan. For good paint adhesion, sand down roll pan completely before applying any primer or paint.
6. After roll pan has been color matched, reinstall on to vehicle.
7. Install the license plate light using the two #8 screws provided. ( DO NOT OVER-TIGHTEN SCREWS ) Snap in the plastic nuts into the square holes in the license plate box. Install your license plate with the
two phillips head screws provided.
8. To wire up the license plate light, connect one wire to the parking light wire from the taillights and the other black wire must be grounded to the frame.
| 
