INSTALLATION INSTRUCTIONS
BOLT-ON STEEL ROLL PAN
93-03 FORD RANGER-SPLASH
PART# 2787101
ACCESSORIES SOLD SEPARTELY:
FLIP-DOWN LICENSE PLATE ASSEMBLY
PART # 300001
For best results, please read all instructions thoroughly prior to attempting installation of your SIR MICHAEL'S weld-on steel roll pan. SIR MICHAEL'S recommends the use of approved hand, eye and ear safety equipment while performing this installation. If you have any questions concerning the installation of your SIR MICHAEL'S steel roll pan, please contact our customer service department at (714) 379-6800, Monday through Friday between the hours of 8:00 a.m. and 4:00 p.m. Pacific Standard Time (PST).
NOTE: Any part that is modified and/or painted are non returnable.
Remove the tailgate and/or rear bumper from truck.
After removing rear bumper you must cut off the fender mounts that are exposed to the rear of the truck. These mounts must be cut off flush to the fender.
Set the top edge of the template to the body line below taillight and the edge of the template to the edge of the fender. Mark the hole where you will need to drill. Then turn template over for the left side and mark the holes.
Drill out the mounting holes with a 5/16" drill bit.
Set the roll pan into place and mark the mounting holes to the bed and behind the rollpan on each end, there is mounting brackets that need to be marked. Remove rollpan and drill 3/16" holes.
Now mount the SIR MICHAEL'S roll-pan using the mounting hardware provided.
Once the SIR MICHAEL'S bolt-on steel pan is properly fitted, remove to be prepped for paint. A lite coat of boy filler is used to fill the seams around the license plate and at the end of the roll pan. For good paint adhesion, sand down roll pan completely before applying any primer or paint.
After roll pan has been color matched, reinstall on to vehicle. Install the license plate light using the two #8 screws provided. ( DO NOT OVER-TIGHTEN SCREWS ) Snap in the plastic nuts into the square holes in the license plate box. Install your license plate with the two phillips head screws provided.
To wire up the license plate light, connect one wire to the parking light wire from the taillights and the other black wire must be grounded to the frame.
| 
